Configuring VPLS Services
Commands
configure service customer description
configure service customer contact
configure service customer phone
Consider the following when configuring customer accounts:
•
The description, contact name, and phone number are not set for the account by default.
•
A default customer account (customer 1) already exists in the switch configuration. This account is
automatically assigned to a service when the service is created.
To verify customer account information, use the
-> show service customer
Customer
Customer-ID 1
Description:
Customer-ID 129
Contact:
Description:
Phone:
Customer-ID 1234
Contact:
Description:
Phone:
Total Customers : 3
Configuring Service Distribution Points (SDPs)
The following tasks are required to configure an SDP:
•
Determine the originating router for the SDP tunnel.
•
Create a locally unique SDP ID number.
•
Obtain the system IP address of the originating and far-end (endpoint) router.
•
Enable Label Distribution Protocol (LDP) Label Switched Paths (LSPs) or assign static LSPs to the
SDP ID.
SDP Configuration Guidelines
Consider the following when configuring SDPs:
•
MPLS is the supported SDP encapsulation type with this implementation. GRE encapsulation is not
supported at this time. As a result, configuring the encapsulation type is not necessary; MPLS is used
by default.
•
The SDP uses the system (Loopback0) IP address to identify the far-end router.
page 11-16
Used for ...
Providing additional information about the account.
Adding a customer contact name to the account.
Adding a contact phone number to the account.
show service customer
Default customer
VJ Smith,
Customer 129,
100-232-4407
John Clark,
Customer 1234,
100-434-1248
OmniSwitch AOS Release 6 Network Configuration Guide
Configuring VPLS
command. For example:
September 2009