Adding The Microsoft Loopback Adapter Driver; Adding The Loopback Adapter Driver To A Windows Nt Server - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Configuring the Server Farm

Adding the Microsoft Loopback Adapter Driver

This section describes how to add Microsoft's loopback adapter to Windows NT servers (see
Loopback Adapter Driver to a Windows NT Server" on page
"Adding the Loopback Adapter Driver to a Windows 2000 Server" on page

Adding the Loopback Adapter Driver to a Windows NT Server

Follow the steps below to add the Microsoft loopback adapter driver to a Windows NT server.
1
Open the Control Panel window by clicking the Start button and then selecting Settings.
2
Double-click the Network icon in the Control Panel window.
Double-click
the "Network"
icon.
3
Click the Adapters tab in the Network window.
Click the "Add..."
button when ready.
4
Click the Add... button.
page 44-16 OmniSwitch AOS Release 6 Network Configuration Guide
Configuring Server Load Balancing
44-16) and Windows 2000 servers (see
44-18).
Click the
"Adapters"
tab.
"Adding the
September 2009