Modifying The Mld Router Timeout; Configuring The Mld Router Timeout; Restoring The Mld Router Timeout; Modifying The Source Timeout - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Configuring IP Multicast Switching
You can also restore the MLD query response interval on the specified VLAN by entering:
-> ipv6 multicast van 2 query-response-interval 0
Or, as an alternative, enter:
-> ipv6 multicast vlan 2 query-response-interval
To restore the MLD query response interval to its default value.

Modifying the MLD Router Timeout

The default MLD router timeout (i.e., expiry time of IPv6 multicast routers) is 90 seconds. The following
subsections describe how to configure a user-specified router timeout value and restore it by using the
ipv6 multicast router-timeout

Configuring the MLD Router Timeout

You can modify the MLD router timeout from 1 to 65535 seconds by entering
ipv6 multicast router-timeout
360 seconds on the system if no VLAN is specified, you would enter:
-> ipv6 multicast router-timeout 360
You can also modify the MLD router timeout on the specified VLAN by entering:
-> ipv6 multicast vlan 2 router-timeout 360

Restoring the MLD Router Timeout

To restore the MLD router timeout to its default (i.e., 90 seconds) value on the system if no VLAN is
specified, use the ipv6 multicast router-timeout
-> ipv6 multicast router-timeout 0
Or, as an alternative, enter:
-> ipv6 multicast router-timeout
To restore the MLD router timeout to its default value.
You can also restore the MLD router timeout on the specified VLAN by entering:
-> ipv6 multicast vlan 2 router-timeout 0
Or, as an alternative, enter:
-> ipv6 multicast vlan 2 router-timeout
To restore the MLD router timeout to its default value.

Modifying the Source Timeout

The default source timeout (i.e., expiry time of IPv6 multicast sources) is 30 seconds. The following
subsections describe how to configure a user-specified source timeout value and restore it by using the
ipv6 multicast source-timeout
OmniSwitch AOS Release 6 Network Configuration Guide
command.
followed by the new value. For example, to set the MLD router timeout to
command by entering:
command.
September 2009
Modifying IPMSv6 Parameters
page 42-31