Installing The Av-Client; Loading The Microsoft Dlc Protocol Stack - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Configuring Authenticated VLANs

Installing the AV-Client

The AV-Client is a proprietary Windows-based application that is installed on client end stations. The
installation instructions are provided in this chapter.
The AV-Client does not require an IP address in order to authenticate; the client relies on the DLC proto-
col (rather than IP) to communicate with the authentication agent in the switch. After authentication, the
client may issue a DHCP release/renew request to get an IP address; a utility in the client software may be
used to configure this automatic request. For information about configuring the utility, see
the AV-Client Utility" on page
The AV-Client software requires three main installation steps as listed here. These steps are slightly differ-
ent depending on the version of Windows you are using.
•
Load the Microsoft DLC protocol stack. See
page 36-13.
•
Load the AV-Client software. See
•
Set the AV-Client as primary network login (Windows 95 and 98). See
Primary Network Login" on page
•
Configure the AV-Client for DHCP (optional). See
page 36-19.

Loading the Microsoft DLC Protocol Stack

Windows 2000 and Windows NT
You must have the DLC protocol installed on your Windows PC workstation before you install the AV-
Client. The installation of the DLC protocol stack may require files from the Windows distribution soft-
ware. Make sure to have your Windows media available during this procedure. Follow these steps to load
the protocol on a Windows workstation.
1
From your Windows desktop, select Start > Settings > Control Panel.
2
Double-click the Network icon. When the Network window opens, select the Protocols tab.
3
Click the Add button and the Select Network Protocol window appears.
4
Select the DLC protocol from the list of Network Protocols. Click OK
5
Follow the screen prompts requesting Windows files.
Windows 98
1
From your Windows desktop, select Start > Settings > Control Panel.
2
Double-click the Network icon. When the Network window opens, select the Configuration tab.
3
Click the Add button and the Select Network Component Type window appears.
4
Select Protocol and click the Add button.
5
When the Select Network Protocol window appears, select Microsoft from the list of manufacturers
and Microsoft 32-bit DLC from the list of Network Protocols. Click
6
Follow the prompts requesting Windows files.
OmniSwitch AOS Release 6 Network Configuration Guide
36-19.
"Loading the Microsoft DLC Protocol Stack" on
"Loading the AV-Client Software" on page
36-19.
September 2009
Setting Up Authentication Clients
"Setting the AV-Client as
"Configuring the AV-Client Utility" on
.
OK
.
"Configuring
36-14.
page 36-13