Creating And Deleting A Static Link Aggregate Group; Creating A Static Aggregate Group; Deleting A Static Aggregate Group - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Configuring Static Link Aggregation Groups

Creating and Deleting a Static Link Aggregate Group

The following subsections describe how to create and delete static link aggregate groups with the
linkagg size command.

Creating a Static Aggregate Group

You can create up to 32 static and/or dynamic link aggregation groups per a standalone switch or a stack
of switches. To create a static aggregate group on a switch, enter static linkagg followed by the user-spec-
ified aggregate number (which can be 0 through 31), size, and the number of links in the static aggregate
group, which can be 2, 4, or 8.
For example, to create static aggregate group 5 that consists of eight links, on a switch, you would enter:
-> static linkagg 5 size 8
Note. The number of links assigned to a static aggregate group should always be close to the number of
physical links that you plan to use. For example, if you are planning to use 2 physical links you should
create a group with a size of 2 and not 4 or 8.
As an option you can also specify a name and/or the administrative status of the group by entering static
linkagg followed by the user-specified aggregate number, size, the number of links in the static aggregate
group, name, the optional name (which can be up to 255 characters long), admin state, and either enable
or disable (the default is enable).
For example, to create static aggregate group 5 called "static1" consisting of eight links that is administra-
tively disabled enter:
-> static linkagg 5 size 8 name static1 admin state disable
Note. If you want to specify spaces within a name for a static aggregate group the name must be specified
within quotes (e.g., "Static Aggregate Group 5").

Deleting a Static Aggregate Group

To delete a static aggregation group from a switch use the no form of the
entering no static linkagg followed by the number that identifies the group. For example, to remove static
aggregate group 5 from a switch's configuration you would enter:
-> no static linkagg 5
Note. You must delete any attached ports with the
static link aggregate group.
page 22-8
static agg agg num
OmniSwitch AOS Release 6 Network Configuration Guide
Configuring Static Link Aggregation
static linkagg size command by
command before you can delete a
September 2009
static