Adding And Deleting Ports In A Static Aggregate Group; Adding Ports To A Static Aggregate Group; Removing Ports From A Static Aggregate Group - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Configuring Static Link Aggregation

Adding and Deleting Ports in a Static Aggregate Group

The following subsections describe how to add and delete ports in a static aggregate group with the
agg agg num command.

Adding Ports to a Static Aggregate Group

The number of ports assigned in a static aggregate group can be less than or equal to the maximum size
you specified in the static linkagg size
static agg agg num
number, agg num, and the number of the static aggregate group. Ports must be of the same speed (i.e., all
10 Mbps, all 100 Mbps, or all 1 Gbps).
For example, to assign ports 1, 2, and 3 in slot 1 to static aggregate group 10 (which has a size of 4) you
would enter:
-> static agg 1/1 agg num 10
-> static agg 1/2 agg num 10
-> static agg 1/3 agg num 10
Note. A port may belong to only one aggregate group. In addition, mobile ports cannot be aggregated. See
Chapter 6, "Assigning Ports to VLANs,"
As an option, you can use the ethernet, fastethernet, and gigaethernet keywords before the slot and port
number to document the interface type or make the command look consistent with early-generation
Alcatel-Lucent CLI syntax. For example, to assign port 1 in slot 1 to static aggregate group 10 and docu-
ment that port 1 in slot 5 is a Giga Ethernet port you would enter:
-> static gigaethernet agg 1/1 agg num 10
Note The ethernet, fastethernet, and gigaethernet keywords do not modify a port's configuration. See
.
Chapter 22, "Configuring Static Link Aggregation,"

Removing Ports from a Static Aggregate Group

To remove a port from a static aggregate group you use the no form of the
by entering static agg no followed by the slot number, a slash (/), and the port number. For example, to
remove port 4 in slot 1from a static aggregate group you would enter:
-> static agg no 1/4
Ports must be deleted in the reverse order in which they were assigned. For example, if port 9 through 16
were assigned to static aggregate group 2 you must first delete port 16, then port 15, and so forth. The
following is an example of how to delete ports in the proper sequence from the console:
-> static agg no 1/24
-> static agg no 1/23
-> static agg no 1/22
OmniSwitch AOS Release 6 Network Configuration Guide
command. To assign a port to a static aggregate group you use the
command by entering static agg followed by the slot number, a slash (/), the port
for more information on mobile ports.
Configuring Static Link Aggregation Groups
for information on configuring Ethernet ports.
static agg agg num
September 2009
static
command
page 22-9