Verifying Map Group Configuration - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Configuring QoS
To delete a map group, use the no form of the policy map group command. The map group must not be
associated with a policy action. For example:
-> no policy map group tosGroup
If tosGroup is currently associated with an action, an error message similar to the following will display:
ERROR: tosGroup is being used by action 'tosMap'
In this case, remove the map group from the action, then enter the no policy map group command:
-> policy action tosMap no map group
-> no policy map group tosGroup
The map group will be deleted at the next qos apply.
Note. For Layer 2 flows, you cannot have more than one action that maps DSCP.

Verifying Map Group Configuration

To display information about all map groups, including all pending and applied map groups, use the show
policy map group command. To display only information about applied map groups, use the applied
keyword with the command. For more information about the output of this command, see the OmniSwitch
CLI Reference Guide.
When the command is used to show output for all pending and applied condition groups, the following
characters may appear in the display:
character definition
+ Indicates that the policy rule has been modified or has
been created since the last qos apply.
- Indicates the policy object is pending deletion.
# Indicates that the policy object differs between the pend-
ing/applied objects.
In the example here, a new map group, tosGroup, has not yet been applied to the configuration.
-> show policy map group
Group Name
+tosGroup
When the qos apply command is entered, the plus sign (+) will be removed from tosGroup in the display.
See "Applying the Configuration" on page 40-54
OmniSwitch AOS Release 6 Network Configuration Guide
From Entries
cli 1-2:5
4:5
5-6:7
for more information about the qos apply command.
September 2009
Using Map Groups
page 40-53