Modifying Dynamic Link Aggregate Group Parameters
Modifying Dynamic Link Aggregate Group
Parameters
The table on
page 23-3
software. These parameters ensure compliance with the IEEE 802.3ad specification. For most networks,
these default values do not need to be modified or will be modified automatically by switch software.
However, if you need to modify any of these default settings see the following sections to modify parame-
ters for:
•
Dynamic aggregate groups beginning on
•
Dynamic aggregate actor ports beginning on
•
Dynamic aggregate partner ports beginning on
Note. You must create a dynamic aggregate group before you can modify group or port parameters. See
"Configuring Dynamic Link Aggregate Groups" on page 23-10
Modifying Dynamic Aggregate Group Parameters
This section describes how to modify the following dynamic aggregate group parameters:
•
Group name (see
•
Group administrative state (see
page
23-15)
•
Group local (actor) switch actor administrative key (see
Aggregate Group Actor Administrative Key" on page
•
Group local (actor) switch system priority (see
System Priority" on page
•
Group local (actor) switch system ID (see
ID" on page
23-16)
•
Group remote (partner) administrative key (see
Administrative Key" on page
•
Group remote (partner) system priority (see
Priority" on page
•
Group remote (partner) switch system ID (see
System ID" on page
Modifying the Dynamic Aggregate Group Name
The following subsections describe how to configure and remove a dynamic aggregate group name with
the
lacp linkagg name
Configuring a Dynamic Aggregate Group name
To configure a dynamic aggregate group name, enter lacp linkagg followed by the dynamic aggregate
group number, name, and the user-specified name, which can be from 1 to 255 characters long.
page 23-14
lists default group and port settings for Alcatel-Lucent's dynamic link aggregation
page 23-14
"Modifying the Dynamic Aggregate Group Name" on page
"Modifying the Dynamic Aggregate Group Administrative State" on
23-16)
"Modifying the Dynamic Aggregate Group Actor System
23-17)
23-17)
23-18)
command.
OmniSwitch AOS Release 6 Network Configuration Guide
Configuring Dynamic Link Aggregation
page 23-18
page 23-23
for more information.
"Configuring and Deleting the Dynamic
23-15)
"Modifying the Dynamic Aggregate Group Actor
"Modifying the Dynamic Aggregate Group Partner
"Modifying the Dynamic Aggregate Group Partner System
"Modifying the Dynamic Aggregate Group Partner
23-14)
September 2009