Configuring The Source Timeout; Restoring The Source Timeout; Enabling And Disabling The Mld Querying; Enabling The Mld Querying - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Modifying IPMSv6 Parameters

Configuring the Source Timeout

You can modify the source timeout from 1 to 65535 seconds by entering
followed by the new value. For example, to set the source timeout to 360 seconds on the system if no
VLAN is specified, you would enter:
-> ipv6 multicast source-timeout 60
You can also modify the source timeout on the specified VLAN by entering:
-> ipv6 multicast vlan 2 source-timeout 60

Restoring the Source Timeout

To restore the source timeout to its default (i.e., 30 seconds) value on the system if no VLAN is specified,
use the ipv6 multicast source-timeout
-> ipv6 multicast source-timeout 0
Or, as an alternative, enter:
-> ipv6 multicast source-timeout
To restore the source timeout to its default value.
You can also restore the source timeout on the specified VLAN by entering:
-> ipv6 multicast vlan 2 source-timeout 0
Or, as an alternative, enter:
-> ipv6 multicast vlan 2 source-timeout
To restore the source timeout to its default value.

Enabling and Disabling the MLD Querying

By default MLD querying is disabled.The following subsections describe how to enable and disable MLD
querying by using the

Enabling the MLD Querying

You can enable the MLD querying by entering
For example, to enable the MLD querying you would enter:
-> ipv6 multicast querying enable
You can also enable the MLD querying on the specified VLAN by entering:
-> ipv6 multicast vlan 2 querying enable
Disabling the MLD Querying
You can disable the MLD querying by entering
keyword. For example, to disable the MLD querying you would enter:
-> ipv6 multicast querying
page 42-32
command by entering:
ipv6 multicast querying
disable
OmniSwitch AOS Release 6 Network Configuration Guide
command.
ipv6 multicast querying
ipv6 multicast querying
Configuring IP Multicast Switching
ipv6 multicast source-timeout
followed by the enable keyword.
followed by the disable
September 2009