Deleting The Pending Configuration; Flushing The Configuration - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Configuring QoS

Deleting the Pending Configuration

Policy settings that have been configured but not applied through the qos apply command may be
returned to the last applied settings through the
-> qos revert
This command ignores any pending policies (any additions, modifications, or deletions to the policy
configuration since the last qos apply) and writes the last applied policies to the pending configuration. At
this point, the pending policies are the same as the last applied policies.
In this example, there are two new pending policies and three applied policies:
Pending Policies
rule5
rule6
If you enter qos revert, the configuration will then look like:
Pending Policies
rule1
rule2
rule3

Flushing the Configuration

In some cases, you may want to remove all of your rules and start over again. To completely erase pend-
ing policies from the configuration, use the
-> qos flush
If you then enter qos apply, all policy information will be deleted.
In this example, there are two new pending policies and three applied policies:
Pending Policies
rule5
rule6
If you enter qos flush, the configuration will then look like:
Pending Policies
In this scenario, you can do one of two things. To write the applied policies back to the pending configura-
tion, use qos revert. Or, to delete all policy rule configuration, enter qos apply. If qos apply is entered,
the empty set of pending policies will be written to the applied policies and all policy rule configuration
will be deleted.
OmniSwitch AOS Release 6 Network Configuration Guide
qos revert
Applied Policies
rule1
rule2
rule3
Applied Policies
rule1
rule2
rule3
qos flush
Applied Policies
rule1
rule2
rule3
Applied Policies
rule1
rule2
rule3
command. For example:
command. For example:
September 2009
Applying the Configuration
page 40-55