Quick Steps For Configuring Dynamic Link Aggregation - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Software release 6
Hide thumbs Also See for OmniSwitch 6850-48:
Table of Contents

Advertisement

Quick Steps for Configuring Dynamic Link Aggregation

Quick Steps for Configuring Dynamic Link
Aggregation
Follow the steps below for a quick tutorial on configuring a dynamic aggregate link between two switches.
Additional information on how to configure each command is given in the subsections that follow.
1
Create the dynamic aggregate group on the local (actor) switch with the
shown below:
-> lacp linkagg 2 size 8 actor admin key 5
2
Configure ports (the number of ports should be less than or equal to the size value set in step 1) with
the same actor administrative key (which allows them to be aggregated) with the
key
command. For example:
-> lacp agg 1/1 actor admin key 5
-> lacp agg 1/4 actor admin key 5
-> lacp agg 3/3 actor admin key 5
-> lacp agg 5/4 actor admin key 5
-> lacp agg 6/1 actor admin key 5
-> lacp agg 6/2 actor admin key 5
-> lacp agg 7/3 actor admin key 5
-> lacp agg 8/1 actor admin key 5
3
Create a VLAN for this dynamic link aggregate group with the vlan command. For example:
-> vlan 2 port default 2
4
Create the equivalent dynamic aggregate group on the remote (partner) switch with the
size
command as shown below:
-> lacp linkagg 2 size 8 actor admin key 5
5
Configure ports (the number of ports should be less than or equal to the size value set in step 4) with
the same actor administrative key (which allows them to be aggregated) with the
key
command. For example:
-> lacp agg 2/1 actor admin key 5
-> lacp agg 3/1 actor admin key 5
-> lacp agg 3/3 actor admin key 5
-> lacp agg 3/6 actor admin key 5
-> lacp agg 5/1 actor admin key 5
-> lacp agg 5/6 actor admin key 5
-> lacp agg 8/1 actor admin key 5
-> lacp agg 8/3 actor admin key 5
6
Create a VLAN for this dynamic link aggregate group with the vlan command. For example:
-> vlan 2 port default 2
page 23-4
OmniSwitch AOS Release 6 Network Configuration Guide
Configuring Dynamic Link Aggregation
lacp linkagg size
command as
lacp agg actor admin
lacp linkagg
lacp agg actor admin
September 2009

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents