Quick Steps For Configuring 802.1Ab - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Configuring 802.1AB

Quick Steps for Configuring 802.1AB

1
To enable the transmission and the reception of LLDPUs on a port, use the
example:
-> lldp 2/47 lldpdu tx-and-rx
2
To control per port notification status about the remote device change on a port, use the
tion command. For example:
-> lldp 2/47 notification enable
3
To control per port management TLV to be incorporated in the LLDPDUs, use the
ment command. For example:
-> lldp 2/47 tlv management port-description enable
4
Set the transmit time interval for LLDPDUs. To set the timer for a 50 second delay, use the
mit interval command. For example:
-> lldp transmit interval 50
5
Set the minimum time interval between successive LDPDUs. To set the interval for a 20 second delay,
use the lldp transmit delay
-> lldp transmit delay 20
Note. Optional. Verify the LLDP per port statistics by entering the
example:
-> show lldp statistics
----------+--------------------------------------+---------------------+----------
| LLDPDU
Slot/Port| Tx
----------+--------+----------+----------+----------+----------+----------+-----
1/23 52
2/47 50
2/48 50
To verify the remote system information, use the
-> show lldp remote-system
Remote LLDP Agents on Local Slot/Port: 2/47,
Chassis ID Subtype
Chassis ID
Port ID Subtype
Port ID
Port Description
System Name
System Description
Capabilites Supported
Capabilites Enabled
For more information about this display, see the OmniSwitch CLI Reference Guide.
OmniSwitch AOS Release 6 Network Configuration Guide
command. For example:
|
Rx Errors Discards |
0 0 0
50 0 0
50 0 0
show lldp remote-system
= 4 (MAC Address),
= 00:d0:95:e9:c9:2e,
= 7 (Locally assigned),
= 2048,
= (null),
= (null),
= (null),
= none supported,
= none enabled,
Quick Steps for Configuring 802.1AB
show lldp statistics
TLV | Device
Unknown Discards | Ageouts
0 0
0 0
0 0
command. For example:
September 2009
lldp lldpdu command. For
lldp notifica-
lldp tlv manage-
lldp trans-
command. For
0
0
0
page 19-3