Xerox B310 Service Manual page 81

S S e e n n s s o o r r ( ( F F u u s s e e r r E E x x i i t t ) ) : : P P a a p p e e r r F F a a i i l l e e d d T T o o C C l l e e a a r r J J a a m m S S e e r r v v i i c c e e C C h h e e c c k k
Action
Step 1
1 Make sure that the fuser exit
area, rear door, and redrive
area are free of jammed paper
or paper fragments
2 Make sure that the rear door
can properly close.
3 Check the rear door for
damage.
Is the rear door functional and
free of damage?
Step 2
1 Enter the Diagnostics menu,
and then navigate to:
Printer diagnostics &
adjustments > Sensor tests
2 Find the sensor (fuser exit).
3 Make sure that the sensor
actuator freely moves and is
not stuck.
Does the sensor status change
while toggling the sensor?
Step 3
1 Remove the right cover. See
Right cover removal.
2 Make sure that the JEXIT1
sensor cable is properly
connected to the controller
board.
Does the problem remain?
Step 4
Replace the rear door. See
door removal.
Does the problem remain?
Step 5
Replace the fuser. See Fuser
removal.
Does the problem remain?
Step 6
Check the redrive for damage.
Is the redrive free of damage?
Yes
Go to step 3.
Go to step 5.
Go to step 4.
Go to step 5.
Rear
Go to step 6.
Go to step 8.
Diagnostics and Troubleshooting
No
Go to step 2.
Go to step 3.
The problem is solved.
The problem is solved.
The problem is solved.
Go to step 7.
Xerox B310 Printer
®
Service Manual
81