Xerox B310 Service Manual page 79

Action
Step 6
1 Remove the right cover. See
Right cover removal.
2 Make sure that the JEXIT1
sensor cable is properly
connected to the controller
board.
Does the problem remain?
Step 7
1 Enter the Diagnostics menu,
and then navigate to:
Printer diagnostics &
adjustments > Motor tests
2 Find the main motor (forward).
3 Open the front door, remove
the imaging unit, and then
close the front door.
4 Activate the motor test.
5 Open the rear door, and then
check if the fuser belt is
properly rotating.
Is the fuser belt properly rotating?
Step 8
1 Remove the right cover. See
Right cover removal.
2 Make sure that the JMTR1
sensor cable is properly
connected to the controller
board.
Does the problem remain?
Step 9
Replace the fuser. See Fuser
removal.
Does the problem remain?
Step 10
Perform a print job.
Does the problem remain?
Yes
Go to step 7.
Go to step 9.
Go to step 9.
Go to step 10.
Go to step 11.
Diagnostics and Troubleshooting
No
The problem is solved.
Go to step 8.
The problem is solved.
The problem is solved.
The problem is solved.
Xerox B310 Printer
®
Service Manual
79