Using Fonts And Scsi Hard Disks - Tektronix Phaser 220e Reference Manual

Chapter
7
Macintosh, PC, and workstation users
Task
Installing fonts
Printing a font sampler
Downloading fonts to the printer
Formatting a SCSI hard disk connected to the printer
Initalizing a formatted SCSI hard disk
Enabling Sys/Start job execution
Disabling Sys/Start job execution
Using Fonts and SCSI
Hard Disks
This chapter explains how to use fonts and SCSI hard disks connected to the
printer. The Þrst few topics tell you how to use fonts in the Macintosh and
PC environments and print a font sampler. The following topics are tasks
that let you format a SCSI disk (for Phaser 220i only; the Phaser 220e does
not have a SCSI port) for font storage, and control Sys/Start Job execution.
Note For general information on fonts, request a document catalog
from HAL, the Tektronix automated fax system. Call
(503) 682-7450 (direct) or, in the U.S. and Canada, call
1-800-835-6100. Refer to Chapter 10, ÒTroubleshooting,Ó
for details on using the HAL system.
The following table for Macintosh, PC, and workstation users describes each
task and gives the appropriate Þle names you use to complete the task.
Workstation users should use the PC utility Þles. The Phaser 220i and 220e
can use the following Þles except as noted in the following table.
Macintosh file name
(see topic ÒUsing
Macintosh screen fontsÓ)
Font Sampler
LaserWriter Utility
Format Printer Disk*
LaserWriter Utility
Set SysStart Job*
No SysStart Job*
Printing Reference
PC file name
(see topic ÒUsing fonts with
WindowsÓ)
FONTS.PS
PSDOWN.EXE (COM port)
PCSEND.EXE (LPT port)
FRMTDISK.PS*
INITDISK.PS*
SYSTART.PS*
NOSYSTRT.PS*
7-1