Tektronix Phaser 220e Reference Manual page 147

3.
View the Þle and substitute the values you want for the values
used in DEVPARAM.PS. The possible values for each parameter
are listed in the table on the next page. The values are
case-sensitive; they must be entered exactly as shown in the table.
When Switch 4 on the Phaser 220i rear panel is down (Switch 2 up
and Switches 3 and 4 down on the Phaser 220e), the default
conditions are these settings: ßow control is Xon/Xoff, parity is
space, 8 data bits, 2 stop bits, baud rate is 9600. Refer to the
printer's user manual for more information about default serial
port conditions.
4. Save the Þle.
5.
ConÞgure the printer port to receive PostScript.
6. PC users: Use the DOS COPY command to send the Þle to the
printer.
To send the Þle to the parallel port, type:
COPY Þlename LPT1:
(or COM1: if you want to send the Þle to the serial port).
Workstation users: ConÞgure the printer port to receive
PostScript, then send the Þle to the printer.
Modifying Printer Operation
Printing Reference
8
8-15