Tektronix Phaser 220e Reference Manual page 131

4.
Double-click on the Þle's self-sending arrow icon. Click OK in the
dialog box to send the desired Þle to the printer.
PC and workstation users
Note If your Sys/Start job fails, set Switch 5 on the printer's back panel
to the up position. You can then reset your printer and the
Sys/Start job is bypassed so that you can correct the error.
1. Locate the Sys/Start Job Þles in the PHSR220 directory on the
Printer Utilities diskette.
2. Copy the Þles to your hard disk, or use the Þles from the diskette.
3.
PC users: Use the DOS COPY command to send a Þle to the
printer. For example, if you want to send the Þle to the parallel
port, type the following at the DOS prompt:
COPY Þlename LPT1:
(or COM1: if you want to send the Þle to the serial port).
Workstation users: ConÞgure the printer port to receive
PostScript, then send a Þle to the printer.
Using Fonts and SCSI Hard Disks
Printing Reference
7
7-15