Devparam.ps (Configuring A Serial Port) - Tektronix Phaser 220e Reference Manual

DEVPARAM.PS (conÞguring a serial port)
To modify DEVPARAM.PS you should be familiar with the PostScript
setdevparams command, and you should know how to use PostScript
dictionaries and key value pairs. When you change the settings for the serial
port, Switch 7 on the printerÕs rear panel must be down for the change to take
effect.
%!
systemdict/languagelevel known {languagelevel 2
eq}{false}ifelse
not {quit} if
mark
{
% Port Settings:
%FlowControl:Dtr/Dsr (Dtr) or Xon/Xoff (XonXoff)
%Parity:Even, Odd, None or Space
%DataBits:7 or 8
%StopBits:1 or 2
%Baud:300,600,1200,2400,4800,9600,19200 or 38400
%
the Phaser II PXe)
% Defaults:
% FlowControl:XonXoff
% Parity:Space
% DataBits:8
% StopBits:2
% Baud:9600
(%Serial_NV%) 6 dict begin
/Password () def
/FlowControl (XonXoff) def
/Parity (None) def
/DataBits 8 def
/StopBits 2 def
/Baud 9600 def
currentdict end setdevparams
} stopped cleartomark
Printing from a Workstation
(Note: 38400 not valid for
Printing Reference
4
4-9