Enabling And Disabling Sys/Start Job Execution - Tektronix Phaser 220e Reference Manual

7
Using Fonts and SCSI Hard Disks

Enabling and disabling Sys/Start Job execution

7-14
Phaser 220 Color Printers
The following Þles control Sys/Start Job execution and apply only to the
Phaser 220i.
The Set SysStart Job (SYSTART.PS) Þle enables automatic execution
of a Þle named SysStart (if one is found) on a hard disk connected
to the printer's SCSI port, each time the printer is turned on or
reset. The Sys/Start job is similar to an Init Þle; it executes
automatically each time the printer is switched on.
The No SysStart Job (NOSYSTRT.PS) Þle disables automatic
execution of the Sys/Start job.
Send one of these Þles to the printer to control Sys/Start Job execution.
Macintosh file name
Set SysStart Job*
No SysStart Job*
*Available only on the Phaser 220i.
Note Switch 5 on the printer's rear panel affects the operation of these
Þles. If Switch 5 is up, Sys/Start Þles are bypassed; if Switch 5 is
down, you can use these Þles to control Sys/Start execution.
Macintosh users
1.
The Sys/Start Job Þles are compressed into the Phaser 220
Utilities.sea archive Þle on the Macintosh Printer Utilities diskette,
and must be decompressed before you can use them. To
decompress these Þles, follow the steps listed under the topic
ÒDecompressing the Macintosh utility ÞlesÓ in Chapter 1, ÒBefore
You Begin.Ó After decompressing these Þles, continue with the
steps listed below.
2.
Select the appropriate printer in the Chooser.
3.
Locate the Sys/Start Job Þles in the folder on your hard disk
containing decompressed utility Þles.
PC file name
SYSTART.PS*
NOSYSTRT.PS*