Tektronix Phaser 220e Reference Manual page 51

Setup dialog box options
Dialog box options
Paper Source
Paper Size
Orientation
Copies
Note If you are printing multiple copies, make sure that the
Transmission Retry (described in the topic ÒConÞguring the
Tektronix driverÓ in this chapter) is set for at least 600 seconds
(10 minutes). Also, you may want to set the number of copies
from your application because the number of copies in the Setup
dialog box remains the same until you change it again.
Option description
If your printer has two trays, select the upper tray, lower
tray, or Auto Select option:
Upper Tray: prints on the paper loaded in the printer's
upper tray.
Lower Tray: prints on the paper loaded in the printer's
lower tray.
Auto Select: prints Þrst from the lower tray until it is
empty, then prints from the upper tray.
Select a paper size from the pop-up menu. Refer to the
ÒPhaser 220 special paper sizesÓ table in Chapter 5,
ÒSelecting Media and Image Options,Ó for a list of paper
sizes and image areas.
Select one of the following options to determine how an
image is placed on the paper:
Portrait (vertical)
Landscape (horizontal)
Type in the number of copies (prints) that you want of a
document.
Printing Reference
3
Printing From a PC
3-13