Printing The Cmyk, Rgb, And Hsb Color Charts - Tektronix Phaser 220e Reference Manual

6
Selecting Color Corrections

Printing the CMYK, RGB, and HSB color charts

6-26
Phaser 220 Drivers and Utilities
Macintosh users
1. Decompress the Phaser 220 Samplers.sea and the Phaser 220
Utilities.sea archive Þles from the Macintosh Printer Utilities
diskette onto your hard disk. Follow the instructions in the topic
ÒDecompressing the Macintosh utility ÞlesÓ in Chapter 1, ÒBefore
You Begin.Ó
2. Determine which color correction utility Þle or switch you want to
use by examining the ÒDriver/File/SwitchÓ table.
3. If you are sending a utility Þle to the printer, do the following:
a.
Select the appropriate printer in the Chooser.
b. Locate the color correction Þle that you want in the folder on
your hard disk containing the decompressed utility Þles.
c. Double-click the color correction ÞleÕs self-sending arrow icon;
click OK in the dialog box to send the Þle to the printer.
4.
To print the color sampler charts, do the following steps:
a. Select the same printer in the Chooser you used in Step 3a.
b. Double-click the ÞleÕs self-sending arrow icon; click OK in the
dialog box to send the Þle to the printer.
5.
Select colors within an application using the colors on the chart.
6. If you are printing from a Tektronix driver: Print your document
using the Tektronix printer driver with the same color correction
option selected in the driver that you used to print the chart. Any
other color correction selection in the driver can cause the colors to
print differently.
If you are not using a Tektronix driver: Print your document
with the same color corrections utility Þle sent to the printer that
you used to print the chart.