Printing From A Macintosh; Using The Macintosh Printer Driver; System Requirements; Installing The Driver - Tektronix Phaser 220e Reference Manual

Chapter
2

Using the Macintosh printer driver

System requirements

Installing the driver

Printing From a
Macintosh
The Tektronix printer driver for the Macintosh requires the following
hardware and software:
An Apple Macintosh II computer (or later)
At least 4 Mbytes of memory
System Software version 6.0.7 or 7.0 and higher
The Phaser 220 driver is a Tektronix-modiÞed version of Apple's LaserWriter
7.1.2 printer driver. This driver includes special paper sizes and TekColor
color correction options. This installation procedure uses Apple's Installer
program to load the software for the Phaser 220 Driver onto your computer's
hard disk. The Installer also loads the LaserWriter 7.1.2 software if you are
using system software 6.0.7.
If the printer is shared on a network, install the same version of the Tektronix
driver on all Macintosh computers connected to the network.
Note LaserWriter 7.1.2 software is required to operate the Tektronix
driver. It is automatically installed for system software 6.0.7
users. If you have system software 7.0 with LaserWriter 7.1.2
already installed, the Installer does not update these Þles.
Printing Reference
2-1