Inserting Validation Forms - TransAct POSjet 1500 Programmer's Manual

Programmer' s Guide

Inserting Validation Forms

®
The POSjet 1500 is designed to run validation either by using application software, or manually. Forms can be
inserted in either landscape or portrait orientation. Regardless of the orientation, the insertion process is the same.
®
The POSjet 1500 can accept forms with measurements between 2.75" x 2.75" (69.8mm x 69.8mm) and 8.5" x 11"
(215.9mm x 279.4mm).
1. Send appropriate control commands from your system to initiate the validation process or press the
Button to enter validation mode.
2. When the
the right edge (form stop) of the validation paper inlet as a guide.
3. When the validation sheet is detected by the sensors, the
steady ON. The paper is automatically drawn into the printer, and printing begins.
4. When the
The side of the inserted form that is facing the front end of the printer is where the printing will always occur.
Always insert forms so that the side of the form that you want the printing to occur on is facing forward.
Nov-07
®
POSjet 1500
starts blinking, insert the validation paper into the validation paper inlet using
begins to blink again after printing, remove the validation paper.
Rev M
Codes and Commands
changes from blinking to
Page 41