Appendix A: Common Operational Questions; Table 69 Common Operator's Questions (Faq's) - TransAct POSjet 1500 Programmer's Manual

Appendix A

Appendix A: Common Operational Questions

Change Paper Rolls
Feed Paper
" " " " ! ! ! !
DO NOT USE ANYTHING OTHER THAN NEW
CARTRIDGES WHEN REPLACING EMPTY
CARTRIDGES
Clean Ink Cartridges
Print Ink Level Status
Cycle Through Configuration Menu
Save Configuration Settings
Exit Self-Test Mode
Exit Configuration Mode
Turning Printer ON
Turning Printer OFF
Removing Ink Low Warning After Installing New Ink Cartridges
Placing Printer Into Self-Test Mode
Entering Configuration Mode
Page 268
®
POSjet
Task
* * * * ! ! ! !

Table 69 Common Operator's Questions (FAQ's)

Rev M
1500
Open the printer's front paper cover. Insert the new paper roll
so that it unwinds from the bottom and rests on the top of the
front cover and aligns with the paper stop on the front cover.
Latch both sides of the paper cover. The paper will load
automatically.
See "Installing a New Paper Roll Using Insta-Load
33.
Press and release the
Press and hold the
Open the printer's front cover. Take the ink cartridge(s) out of
the carriage system and replace with new cartridge(s). Press
and release the
See "Installing Ink Cartridges", on page 31.
Press and release the
the cartridge still is not working correctly, replace the
cartridge(s).
Press and release the
Follow the directions that print on the configuration summary
receipt after entering Configuration Mode.
Press and release the * Button at any time.
Press and release the * Button at any time.
Press and release the * Button at any time.
Press and release the * Button.
Press and release the * Button.
Press and release the
after installing the new ink cartridge(s).
1. Press and release the * Button to place the printer into
STANDBY/OFF mode. (The
be off.)
2. Press and hold the
3. While holding the
release the * Button.
4. When the red,
ERROR INDICATOR LIGHT
the
5. Follow the directions printed on the receipt to select the
desired TEST option.
1. Unplug the power cord from the printer.
2. Press and hold the
cord back into the printer.
3. Continue to hold the
begins to blink.
INDICATOR LIGHT
4. Release the
Configuration Summary Receipt shows how your printer
is configured. Follow the directions at the bottom of the
receipt to change and save settings.
5. See " Configuration Mode" on page 47.
Programmer' s Guide
Approach
®
", on page
Button for a single line.
Button for continuous feed.
Button.
Button 2-3 times. If
Button.
Button immediately
POWER INDICATOR LIGHT
Button.
Button, press and
blinks, release
Button.
Button and plug the power
Button until the
ERROR
Button. A receipt will print. This
Nov-07
will