TransAct POSjet 1500 Programmer's Manual page 238

EPOS Control Codes
Select Paper Type for Command Settings
Function
ASCII [ESC] c 1 <n>
Hexadecimal
1BH 63H 31H <n>
Decimal
<27> <99> <49> <n>
n = 1, 1 ≤ n ≤ 3, 8 ≤ n ≤ 11
Range
Description ESC c 1 n selects paper type(s) for setting. Paper roll and validation paper are available. Both bits
0 and 1 indicate paper roll and if either of them is available, the paper roll is selected as the print
sheet. The commands that need to select paper types for setting are ESC 2, ESC 3, GS L, and GS
W. The value of n is used as follows:
Bit Off/On
0
1
2
3
4–7
Select Paper Type for Command Settings
Function
ASCII [ESC] f <t
Hexadecimal 1BH 66H <t
Decimal <27> <116> <t
Range
0
0 ≤ t ≤ 64
2
Description ESC f t1 t2 sets the time that the printer waits for validation paper to be inserted to
and the time from detection of the validation to the start of printing to
t1=0, the validation waiting time is not set and the printer continues waiting for a validation to be
inserted. The default validation waiting time is not set, and the start operation time is set to 10
seconds (
waiting for a validation to be inserted. The setting becomes effective when validation paper is
used. DLE ENQ is used to cancel the validation waiting state.
Page 224
POSjet
Hex
Off 00
On 01
Off 00
On 02
— —
Off 00
On 08
— —
><t >
1 2
><t >
1 2
><t >
1 2
t =0, t =10). This setting alone, however, does not cause the printer to immediately start
1 2
Rev M
®
1500
Decimal
0 Not Used.
1 Not Used.
0 Paper roll disabled.
2 Paper roll enabled.
— Undefined.
0 Validation paper disabled.
8 Validation paper enabled.
— Undefined.
≤ t
1
Programmer' s Guide
Function
× 1 minutes,
t
1
× 0.1 seconds. When
t
2
Nov-07
≤ 15