Control Codes
Connecting the DC Power Cord (no power supply)
1.
Orientate the printer upside-down and find the DC power socket.
2.
Locate the DC power cord and connect it to the Interface Card's power socket, then route the cord through the
cable restraint. Failure to use the cable restraints may result in the printer becoming accidentally unplugged
during operation.
3.
Set the printer into OPERATIONAL/ON mode by pressing the * Button. The printer takes 1.5 seconds to begin
operation.
Figure 18 Connecting the DC Power Cord (no power supply)
Page 28
®
POSjet
1500
Rev M
Programmer' s Guide
Nov-07