Table 61 Printing Position Of Hri Characters; Table 62 Font For Human Readable Interpretation (Hri) Characters - TransAct POSjet 1500 Programmer's Manual

Programmer' s Guide
The following apply to both
GS k <m> <dl> ... <dk> NUL
GS k <m> <n> <dl> ... <dn>:
If the horizontal width exceeds the printing area, the printer only feeds the paper.
commands feed as much paper as necessary to print the bar code according to the GS h command.
These commands are enabled only when no data exists in the print buffer. When data does exist in
the print buffer, the printer processes the data following <m> as normal data. After printing a bar
code, the print position is set at the beginning of the line. These commands are not effected by
print modes (emphasized, underline, character size, etc.)
Note: Barcode 39 allows the "*" character to be used as a start and stop flag. If the "*" is used, the
length specified must be at least as long as the desired barcode.
Function Set Bar Code Height
ASCII
GS h <n>
Hexadecimal
1DH 68H <n>
Decimal <29> <104> <n>
1 ≤ n ≤ 255
Range
Default 0.90 inch high
Description The GS h <n> command sets the height of the bar code. The bar code height is set to n/180 inch.
Function Select Printing Position of HRI Characters
ASCII
GS H <n>
Hexadecimal
1DH 48H <n>
Decimal <29> <72> <n>
0 ≤ n ≤ 3, 48 ≤ n ≤ 51
Range
Description
The GS H <n> command selects the printing position of HRI (Human Readable Interpretation)
characters when printing a bar code. <n> selects the printing position as follows.
<n>
0, 48
1, 49
2, 50
3, 51
Function Select Font for HRI Characters
ASCII GS f <n>
Hexadecimal 1DH 66H <n>
Decimal <29> <102> <n>
Range
<n> = 0, 1, 48, 49
Description
The GS f <n> command selects a font for the HRI (Human Readable Interpretation) characters
used when printing a bar code. <n> selects a font from the following table.
<n>
0, 48
1, 49

Table 62 Font for Human Readable Interpretation (HRI) Characters

Nov-07
®
POSjet 1500
Not printed
Above bar code
Below bar code
Both above and below the bar code

Table 61 Printing Position of HRI Characters

Font A (14 x 12)
Font B (12 x 12)
Rev M
Printing position
Font
EPOS Control Codes
These
EPOS ONLY
EPOS ONLY
EPOS ONLY
Page 229