TransAct POSjet 1500 Programmer's Manual page 150

Control Codes
Receipt or
Inserted Form
Offset O
Note 1:
O + X must be less than 520 and greater than 96.
Note 2:
The value of X * Y must be less than or equal to 411,840.
Note 3: Y is internally rounded up to the nearest multiple of 12. For example if you want the height to be
3.1 inches, B = 3.1*192 or 595.2 dots. 595.2 will be rounded up to 600 or 3.125 inches. If
rounding up results in X * Y being greater than 411,840 dots, the value of Y will be reduced by 12
to 588 or 3.06 inches. The smallest possible value is 96.
Function Set Page Mode Entry Position
ASCII [ESC] o <Y
Hexadecimal
1BH 6FH <Y
Decimal
<27><111> <Y
IPCL
&%PY<y
EPOS [ESC] W
Description This command sets vertical entry position to anywhere on the page. It is only valid in page mode.
If the value specified is beyond the page boundary, the command is ignored. (Y refers to the
current active orientation specified by the [ESC]t command and is not same as the page definition
of X and Y.
The Y position is in dots and the resolution depends on the current orientation.
Y = Y * 256 + Y
h
Note:
You can also use the [ESC]J, [ESC]M. [ESC]d and [ESC]e commands to position the print on the
page.
Page 136
POSjet
Width X
><Y >
L H
><Y >
L H
><Y >
L H
> <y > <y >
1 2 3
dots from the top
l
Rev M
®
1500 Programmer' s Guide
Nov-07