TransAct POSjet 1500 Programmer's Manual page 123

Programmer' s Guide
Function Set form length in inches
ASCII [ESC] C [NUL] <n>
Hexadecimal
1BH 43H <0> <n>
Decimal
<27> <67> <0> <n>
IPCL
&%SI <m
EPOS none
Description The [ESC] C [NUL] <n> command sets the form length to <n> inches. If the current page
position is greater than the new page length, the command also sets the current position as the top
of form. If zero inches are specified, the form feed and vertical tab commands are ignored.
Function Begin auto line feed
ASCII
[ESC] 5 <n>
Hexadecimal
1BH 35H <n>
Decimal
<27> <53> <n>
IPCL &%MA (Begin)
IPCL &%CA (End)
EPOS none
Description
The [ESC] 5 <1> command sets auto line feed mode. [ESC] 5 <0> command ends auto line feed
mode.
Note 1
The begin and end auto line feed command overrides the configuration setting.
Function Reverse line feed
ASCII
[ESC] ]
Hexadecimal
1BH 5DH
Decimal <27> <93>
IPCL &%LR
EPOS none
Description The [ESC] ] command performs a reverse line feed at the current line spacing.
Note 1 The POSjet
Nov-07
POSjet
> <m >
1 2
®
1500 Printer can tolerate no more than 1/2 inch of reverse feed.
Rev M
®
1500 Codes and Commands
Page 109