Paper Out; Cash Drawer Dialog - TransAct POSjet 1500 Programmer's Manual

®
Control Codes POSjet 1500 Programmer' s Guide

Paper Out:

Ignore Paper Out:
If this is selected, the print functions will still attempt to print to the printer even when paper out is sensed. This
functionality is provided to maximize paper use on the Ithaca Series 90 printer that reports paper out as a function of
the number of print lines since paper low is sensed. Use on printers other than the Series 90 is not recommended.
You must have printer configuration "Paper Out Mode" set to "Disabled" to use this functionality.
Do not Report Paper Out:
If this is selected, the printer driver will not report that paper is out even when paper out is sensed. This
functionality is provided to maximize paper use on the Ithaca Series 90 printer that reports paper out as a function of
the number of print lines since paper low is sensed. Use on printers other than the Series 90 is not recommended.
You must have printer configuration "Paper Out Mode" set to "Disabled" to use this functionality.

Cash Drawer Dialog

Drawer 1 or 2:
Select which drawer is the default cash drawer that is fired. This default setting can be overridden at run time via
"DirectIO". See: "PcOS OPOS Reference Manual" (PcOSOPOS.doc) for more information.
Drawer Open Status Immediately:
If set, the driver will begin to report that the cash drawer is open as soon as the command is given to open the
drawer. This option is provided to allow for applications that expect different event timing than the hardware
generates.
Reverse Drawer Open Sensor Detection:
Some cash drawer sensors are wired opposite than expected. An example of this can be seen when comparing the
difference between (Normally open NO) vs (Normally closed NC). This setting allows for a cash drawer whose
sensor is connected differently than expected.
Number of Drawer Open Retries:
If non-zero and the cash drawer fails to open, the cash drawer driver will try to re-fire the cash drawer at
approximately 2 second intervals the number of times specified.
Wait For Drawer Open Timeout:
This is the time that the OpenDrawer() function will wait for the cash drawer to open. If the drawer does not open
within this time, the function will return an OPOS_E_TIMEOUT. If set to -1 (0xffffffff), OpenDrawer() method will
never time out.
Message Beep Type:
Normally set to -1. When set to -1 will use PCs speaker as a beeper. This value is passed to the windows API
MessageBeep() function.
Drawer Wait Timeout:
Time in milliseconds that WaitForDrawerClose() method will wait before returning a OPOS_E_TIMEOUT. If set to
-1 (0xffffffff), WaitForDrawerClose() method will never time out.
Page 72 Rev M Nov-07