Table 65 Peripheral Device Bit Definitions - TransAct POSjet 1500 Programmer's Manual

EPOS Control Codes
Function Generate Pulse
ASCII [ESC] p <m> <t
Hexadecimal
1BH 70H <m> <t
Decimal
<27> <112> <m> <t
Range
<m> = 0, 1, 48, 49
0 ≤ t1 ≤ 255
0 ≤ t2 ≤ 255
Description
The [ESC] p <m> <t
connector pin. When <m> = 1 or 48, the pulse is sent to drawer-kick-out connector pin 2. When
<m> = 0 or 48, the pulse is sent to drawer-kick-out connector pin 2; when <m> = 1 or 49, the
pulse is sent to drawer-kick-out connector pin 5.
Function Select Peripheral Device Status
ASCII [ESC] = <n>
Hexadecimal
1BH 3DH <n>
Decimal
<27> <61> <n>
Range 1 ≤ n ≤ 3
Description
The [ESC] = <n> command selects the device to which the host computer sends data, based on the
value of <n> listed below.
Bit Off/On
0 Off
On
1 Off
On
2-7 -
Note 1
In TM-U325D mode, the value of <n> must be <2> to enable the display, and <1> to enable the
printer. This does not match the Epson documentation, but is how the TM-U325D works. The
®
POSjet
both.
Function Real-Time Request to Printer
ASCII [DLE] [ENQ] <n>
Hexadecimal 10H 05H <n>
Decimal
<16> <5> <n>
Range
<n> = 0, 2
Description
The [DLE] ENQ <n> command responds to a request from the host computer specified by <n> as
shown below. The command is also executed when the printer is disabled. When the printer stops
printing due to a paper-end condition, <n> = 0 is only effective when the printer is waiting for on-
line recovery from the time the paper roll is inserted to the time the printer goes on-line. The on-
line recovery wait time is confirmed by the printer status of ASB or the [DLE] EOT command.
<n> = 2 is only effective when a recoverable error occurs. The printer can recover from an error
without turning off the power. Whether an error occurs or not can be confirmed by the ASB status
or the error status of the [DLE] EOT command.
Where <n>
0
2
Page 232
POSjet
> <t >
1 2
> <t >
1 2
> <t >
1 2
> <t > command sends a pulse (on time = <t
1 2
Hex Decimal
00H <0>
01H <1>
00H <0>
02H <2>
-

Table 65 Peripheral Device Bit Definitions

1500 Printer matches the TM-U325D in TM-U325D mode. In EPOS mode, you may do
Recovers to on-line
Recovers from an error after clearing the receive and print buffers
Rev M
®
1500
Printer disabled
Printer enabled
Customer display disabled
Customer display enabled
- Undefined
Programmer' s Guide
> x 2 msec) to the specified
1
Function
Nov-07