TransAct POSjet 1500 Programmer's Manual page 174

Control Codes
Function Set Wait for slip removal timeout
ASCII [ESC][EM]D<n>
Hexadecimal
1BH 19H 44H<n>
Decimal
<27> <25><68><n>
IPCL
None
EPOS
Description This command sets the period of time the printer will wait for the form or check to be removed
from the printer before the next print operation occurs. The default is to wait forever.
Where n = 0
1
2
3
...
255
Function Set Slip Sense Delay
ASCII [ESC][EM]V<n>
Hexadecimal
1BH 19H 56H<n>
Decimal
<27> <25><86><n>
IPCL
None
EPOS
Description This command sets the period of time the printer will wait after the form is sensed before the
validation drive starts. This time allows the operator time to position the form before the printer
secures it. The default is a pause of 300 mS.
Where n =
1
...
30
...
255
Typical values are from 200 to 400 mS.
Function Set validation slip stop
ASCII
[ESC][EM]L<n>
Hexadecimal
1BH 19H 4CH<n>
Decimal
<27> <25><76><n>
IPCL None
EPOS
Description This command sets the load position of the form or check in millimeters. The value of <n> may
be from 3 to 40 mm. Values greater than 40 will be accepted, however will cause a paper jam if
the form is greater than 70mm (2.75") wide. This command over rides any configured values.
Note 1: This command effects only the [ESC]j command.
Note 2: This value may be set as part of the configuration process.
Function Cancel Validation Waiting
ASCII
[ENQ] <16>
Hexadecimal
05H 10H
Decimal
<5> <16>
Description The [ENQ] <16> causes the printer to stop waiting for a validation form and return receipt mode.
Response
[ACK] <16> Wait canceled
[NAK] <16> Printer was not waiting
Page 160
POSjet
Wait forever
1 Second ( 1 is a special case that has a very short wait time.)
10 Seconds
30 Seconds
and so on where the time is n * 10 seconds.
42.5 minutes.
10 mS
300 mS.
2.55 seconds.
Rev M
®
1500 Programmer' s Guide
Nov-07