Connecting The Power Cord (With Power Supply); Figure 17 Connecting The Ac Power Cord (With Power Supply) - TransAct POSjet 1500 Programmer's Manual

Programmer' s Guide
®
The POSjet 1500 Printer may be powered from an external 24 Vdc power source, or may be equipped with a
factory installed PowerPocket
specifications.

Connecting the Power Cord (with power supply)

1. Orientate the printer upside-down and find the POSjet's power supply's power socket.
2. Locate the power cord and connect it to the power socket (power supply) located on the back of the printer and
to an external power outlet. The socket-outlet shall be installed near the equipment and shall be easily
accessible.
3. Route the power cord through the cable restraints. Refer to the drawing below to see how to route the cord.
Failure to use the cable restraints may result in the printer becoming accidentally unplugged during operation.
4. Set the printer into OPERATIONAL/ON mode by pressing the * Button. The printer takes approximately 1.5
seconds to begin operation.

Figure 17 Connecting the AC Power Cord (with power supply)

Nov-07
®
POSjet 1500
®
power supply. Refer to the specification section for DC power connector
Rev M
Codes and Commands
Page 27