Table 32 Language Table Id's - TransAct POSjet 1500 Programmer's Manual

Programmer' s Guide
Character sets and Code Pages
®
The POSjet 1500 Printer supports 65 different international character sets. In IBM and EPOS printers, there are two
ways of selecting a character set. One way substitutes international characters in the upper 128 characters of a
standard character set. The substitution technique supports a few different countries. However, as more and more
countries were added, too many characters were being replaced. It became a problem for the application to match
the characters displayed and printed. To solve the problem, a second method of selecting a character set was
developed - code pages. The printer and display use the same code page. The application displays and prints the
same characters. IBM and EPOS defined new commands to select code pages and left the old commands in effect.
®
The POSjet 1500 Printer supports international character sets as well as code pages. To allow the most flexibility
for the application programmer, both methods are extended in the POSjet
character sets and 60 code pages. In EPOS mode, there are 57 character sets and five code pages.
®
The POSjet 1500 Printer allows the IBM code page selection command to choose character sets as well as normal
IBM code pages. The EPOS character set select command has been extended to allow additional character sets over
and above the 11 defined by EPOS. The EPOS code page select command has not been extended because there is
no EPOS definition beyond the first six ID's.
All characters in code pages as well as character sets are addressed as zero through 255. (Characters below 32 must
be addressed with the [ESC] ^ <n> command.) Code pages may be changed at any time and are active for all
features including rotated print. To allow other code pages to be created by an application, a redefine character set
command is provided.
As discussed above, there are two commands for language selection in IBM mode. The first is [ESC] !, which
selects one of 19 international character sets. The [ESC]! command does not allow all of the possible character sets
to be selected, it is provided for compatibility with older programs only. The second is [ESC][ T, which selects any
of the 58 code pages. In EPOS mode, the [ESC] R command has been expanded to select any of the 59 international
character sets or code pages.
Function Select international character set
ASCII
[ESC] ! <n>
Hexadecimal
1BH 21H <n>
Decimal
<27> <33> <n>
IPCL
&%CS <n>
EPOS [ESC] R <n>
Description The [ESC] ! <n> command selects international character set <n>. In standard mode, the value of
<n> is as follows.
<n>
64-'@'
65-'A'
66-'B'
67-'C'
68-'D'
69-'E'
70-'F'
71-'G'
72-'H'
Function Select character code page
11
Epson provides limited code page support through ID to code page translation.
defined.
12
There is an Arabic Character set available on special order with some emulation restrictions.
Nov-07
POSjet
Language
ASCII (slashed zero)
ASCII (unslashed zero)
British
German
French
Swedish
Danish
Norwegian
Dutch

Table 32 Language Table ID's

12
Rev M
®
1500
®
1500 Printer. In IBM mode, there are 19
<n>
73-'I' Italian
74-'J' French Canadian
75-'K' Spanish
76-'L' Swedish II
77 -'M' Swedish III
78-'N' Swedish IV
79-'O' Turkish
80-'P' Swiss I
81-'Q' Swiss II
Codes and Commands
11
Language
Only six translations are
Page 115