Table of Contents
Advertisement
Control Codes
Printing the Configuration Summary Receipt
This printer has been shipped with a pre-printed, Configuration Summary Receipt that shows how the printer has
been configured at our factory. This Configuration Summary Receipt can be found in the paper compartment of your
printer. Save this receipt for future reference. In the event that you need to view your printer's configuration settings,
but do not have your Configuration Summary Receipt, you can print a new one using the printer's self-test mode.
Use the configuration summary receipt to compare printer configuration settings to your system requirements.
Specific attention should be given to ensure that the emulation and the communications link are properly configured.
If they do not match the settings of your system, the printer may appear inoperative.
Follow the steps below to print a new Configuration Summary Receipt:
Placing the Printer In Self-Test Mode (printing the Configuration Summary
Receipt)
The
Button is used to enter the POSjet's self-test mode. To place the POSjet
first be sure that a paper roll is loaded and that the
1.
If the
STANDBY/OFF mode.
2.
Press and hold the
3.
While holding the
4.
When the red,
5.
You are now in self-test mode. Read the directions on top of the printed receipt to cycle through the menu
options.
6.
Select the "TEST-PRINT CONFIGURATION" menu option.
Exiting Self-Test Mode
Exit Self-Test mode at anytime by pressing the * Button to place the printer back into OPERATIONAL/ON mode.
At this point, your printer should be completely installed and ready to accept commands. Refer to our on-line
Operator's Guide for additional information about setup troubleshooting, printer specifications, and
operational information.
Matching Printer Configuration Settings to your System
If you are experiencing inconsistent printing operation, or if the printer appears to be non-responsive, several of the
printer configuration settings need to be set to match the requirements of your system.
Parallel Printer
Emulation
Carriage Return Options
Serial Printer
Emulation
RS-232 Serial Interface (baud rate)
Carriage Return Options
TransAct recommends that ONLY THE ABOVE SETTINGS BE ALTERED and does not recommend that these
re-configurations be made by anybody but a trained service technician who has successfully completed
®
training on the POSjet
1500. Please remember that these settings are only a few of the possible configurable
options. If you continue to experience incompatibility issues after changing these settings to match your
system, contact TransAct's Technical Support Department for assistance.
Page 34
®
POSjet
1500
is illuminated, press and release the * Button to turn the printer into
Button.
Button, press and release the * Button.
blinks, release the
Rev M
Programmer' s Guide
®
in self-test mode,
is off.
Button.
Nov-07
Advertisement
Table of Contents
Troubleshooting
