Opos Drivers Installation Instructions; To Install The Usb Drivers - TransAct POSjet 1500 Programmer's Manual

Control Codes

OPOS Drivers Installation Instructions

Run SetupOPOS.exe.
The communications will default to "COM2". If the communication port is not setup at installation, the first time
the printer service object Open method is called, a Comm port setup dialog will be displayed. After running
Setup.exe there will be a OPOS setup utility in the OPOS program group/start menu and also in the control panel.
Use this utility to setup the OPOS printer "driver" and cash drawer "driver". To Install the USB drivers:
Ensure that USB is enabled in your system s BIOS. To verify that USB is enabled, Click on "Start", "Settings",
"Control Panel". Double click "System" and select the "Device manager". If you see "Universal Serial Bus
Controllers" in the list, USB is enabled. Check your PC s documentation for more information about USB if needed.
Ensure that power is applied to the printer and plug in the USB cable to both the PC and printer.
Follow the on screen directions. Please note that several drivers are installed in this process. Therefore the "Found
new hardware" prompt will appear several times. If the system needs, direct it to the location of the USB driver
install disk (usually the floppy drive).
See "readme.txt" or "usbman.htm" on the install disk for more information.

To Install the USB drivers

1. Ensure that USB is enabled in your system s BIOS. To verify that USB is enabled, Click on "Start",
"Settings", "Control Panel". Double click "System" and select the "Device manager". If you see
"Universal Serial Bus controllers" in the list, USB is enabled. Check you PC s documentation for more
information about USB if needed.
2. Ensure that power is applied to the printer and plug in the USB cable to both the PC and printer.
3. Follow the on screen directions. Please note that several drivers are installed in this process. Therefore the
"Found new hardware" prompt will appear several times. If the system needs, direct it to the location of the
USB driver install disk (usually the floppy drive).
See "readme.txt" or "usbman.htm" on the install disk for more information.
Page 66
®
POSjet 1500
Rev M
Programmer' s Guide
Nov-07