Mechanism Control Commands - TransAct POSjet 1500 Programmer's Manual

EPOS Control Codes

Mechanism Control Commands

Function Select cut mode and cut paper
ASCII
[GS] V <m> <n>
Hexadecimal
1DH 56H <m> <n>
Decimal
<29> <86> <m> <n>
Description
When <m> = 1 or 49, <n> is not used and a partial cut is performed. When <m> = 66, [GS] V
<m> <n> executes a partial cut (one point left uncut) after paper is fed [cutting position (<n> x
approximately 1/144 inch)]. When using the command, there is a gap between the auto-cutter
position and the print position. The [GS] V <m> <n> command is only effective when input at the
beginning of a line. The [GS] V <m> <n> command executes paper feeding to the manual cutting
position.
Function Partial knife cut
ASCII
[ESC] i
Hexadecimal 1BH 69H
Decimal <27> <105>
Description The [ESC] i command performs a partial knife cut.
Function Perform a partial knife cut
ASCII
[ESC] m
Hexadecimal
1BH 6DH
Decimal <27> <109>
Description
The [ESC] m command performs a partial knife cut.
Function Sound buzzer
ASCII
[BEL]
Hexadecimal 07H
Decimal <07>
Description
The [BEL] command sounds the internal buzzer, if equipped.
Function Sound buzzer
ASCII
[ESC] BEL
Hexadecimal
1BH 07H
Decimal
<27> <07>
Description
The [ESC] BEL command sounds the internal buzzer, if equipped.
Function Load Check for Processing
ASCII [FS] a 1
Hexadecimal 1CH 61H 31H
Decimal <28> <97> <49>
Description Position a form to the top edge. This command is typically used to print the face of a check in
rotated print mode. It will feed the check into the printer so the top of the check is in position to
print. See "Validation Form Requirements" on page 16.
Page 230
®
POSjet 1500
Rev M
Programmer' s Guide
EPOS ONLY
EPOS ONLY
EPOS ONLY
EPOS ONLY
EPOS ONLY
Nov-07