TransAct POSjet 1500 Programmer's Manual page 188

Control Codes
Function Open Cash Drawer
ASCII [ESC] x <n>
Hexadecimal
1BH 78H <n>
Decimal
<27> <120> <n>
IPCL
&%D1 (Cash Drawer 1)
&%D2 (Cash Drawer 2)
EPOS [ESC] p
Description The [ESC] x <n> command charges the cash drawer, <n>, for 150 ms.
Where <n> =
<1> (01H) or 1 (31H) for Cash Drawer 1<2> (02H) or 2 (32H) for Cash Drawer 2
The time period that drawer is activated can be changed in the configuration menu. Activation
time ranges from 25 ms to 250 ms.
Note 1
Cash drawer open commands are processed as part of print data. They are not immediate
commands and are not processed until found in the input buffer by the print processor.
Note 2
Cash drawer 2 is factory configurable in one of two modes. Either pin 2 or 3 is active depending
on an internal jumper setting. The factory default is pin 3. Cash Drawer 1 is always on pin 2.
The cash drawer status is defined as an open circuit for drawer closed.
Function Perform Auto Cut
ASCII
[ESC] v
Hexadecimal
1BH 76H <n>
Decimal
<27><118>
IPCL
&%FC
EPOS [ESC] i or [ESC] m
Description The [ESC] v command operated the auto cutter.
Note 1
The auto cutter is optional. If the auto cutter is not installed this command will be ignored.
Function Initialize the Printer
ASCII [ESC] @
Hexadecimal 1BH 40H
Decimal
<27> <64>
Description
The [ESC] @ command initializes the printer. All settings, including character font and line
spacing, are canceled.
Function Audio Alert
ASCII
[BEL]
Hexadecimal
07H
Decimal <7>
IPCL
&%BL
EPOS
[BEL]
Function
When enabled, the [BEL] command starts the audio alert sequence.
Description
The default is a single sound, lasting the period of time defined by the audio alert setting. If the
audio alert is off, it does not function.
Page 174
POSjet
&%PC
Rev M
®
1500 Programmer' s Guide
Nov-07