TransAct POSjet 1500 Programmer's Manual page 149

Programmer' s Guide
Command Active
Cash drawer Yes
commands
Bell command Yes
Auto cut commands Delayed
Electronic journal No
station select
Electronic journal Yes
entries
Station selects Delayed
and form load
commands
Status requests Yes
Printer initialize Yes
command
Set top of form No
Vertical tab No
Macro definitions No
Function Set Page Mode Page Size
ASCII
[ESC] u <O
Hexadecimal
1BH 75H <O
Decimal
<27><117> <O
IPCL &%PS <o
EPOS
[ESC] W
Description
This sets the page size and position for data entry while in page mode. It is not valid during page
definition and must be issued before page definition starts.
The offset O is defined from the right edge of the print zone and is O
per inch. The Width is X
greater than 520 dots or 2.5 inches. The height is defined by Y
inch.
If the values specified by this command are out of range, the command will create the largest size
possible page definition with the X direction taking priority. If either X or Y is specified as 0, the
maxim value for that direction will be calculated and used. Specifying 0 for all the parameters
will restore the printer to the default of 520 in the X direction and 792 in the Y with no offset.
Nov-07
POSjet
Action
Immediate action
Immediate action
The printer will perform a feed to cut and then operate the auto
cutter after the page is printed. The cut command may be
anywhere in the definition. If the page is printed twice, the Auto
cut command must be reissued after the first print to generate
additional cuts.
This command is like a station select and is not active. You
cannot store page mode images in the electronic journal. A
page mode command in journal station mode will exit journal
mode.
You can make journal entries as part of a page description.
They are saved as text and not part of the page.
Any validation select and check load commands found in the
page definition, are delayed until the page is printed. If the page
is printed more than once, the form load commands must be
reissued.
commands in page mode below.
The status is returned during definition.
Cancels page mode definition and returns the printer to standard
mode.
You must set the top of form outside of page mode. The form
position is maintained after the page is printed.
The definition of a vertical tab is ambiguous in page mode and
is ignored.
You can not define or delete a macro while in page mode. You
can, however, invoke a macro or stored graphic. You can not
enter page mode while in a macro definition.
><O ><X ><X ><Y ><Y
L H L H L
><O ><X ><X ><Y
L H L H
><O ><X ><X ><Y
L H L H
><o > <o ><x ><x > <x
1 2 3 1 2
* 256 + X
h
Rev M
®
1500
See the section on embedding station select
>
H
><Y >
L H
><Y >
L H
><y ><y > <y >
3 1 2 3
dots at 208 dots per inch. The sum on O + X must not be
l
Codes and Commands
* 256 + O dots at 208 dots
h l
* 256 + Y dots at 192 dots per
h l
Page 135