Panel Button Commands - TransAct POSjet 1500 Programmer's Manual

Programmer' s Guide
Function Set Character Size
ASCII GS ! <n>
Hexadecimal
1DH 21H <n>
Decimal
<29> <33> <n>
Description
The GS ! <n> command sets the horizontal and vertical scaling. The upper nibble is the horizontal
scale, and the lower nibble is the vertical scale. The minimum size is x1, and the maximum size is
x2.
Where <n>
xxxx0000
xxxx0001
0000xxxx
0001xxxx
Function Begin Italics
ASCII [ESC] 4
Hexadecimal 1BH 34H
Decimal
<27> <52>
Description
The [ESC] 4 command begins italics print mode.
Note 1 Italics are not available in all print modes.
Function End Italics
ASCII
[ESC] 5
Hexadecimal
1BH 35H
Decimal
<27> <53>
Description
The [ESC] 5 command ends italics print mode.

Panel Button Commands

Function Enable/Disable Paper Feed
ASCII [ESC] c 5 <n>
Hexadecimal 1BH 63H 35H <n>
Decimal <27> <99> <53> <n>
0 ≤ n ≤ 255
Range
Description The [ESC] c 5 <n> command enables or disables the
(LSB) of <n> = one, the
prevent problems caused by accidentally pressing the
The
time set by the [GS] z 0 command for paper insertion and during the recovery confirmation time.
Where <n> Bit 0 = 1 the
Bit 0 = 0 the button is enabled.
Nov-07
®
POSjet
Vertical scale 1
Vertical scale 2
Horizontal scale 1
Horizontal scale 2
Button is disabled; when it is zero, the button is enabled. To
Button is temporarily enabled, regardless of how the command is set during the wait
Button is disabled
Rev M
1500
Button. When the least significant bit
Button, use the command to disable it.
EPOS Control Codes
EPOS ONLY
EPOS ONLY
EPOS ONLY
Page 213