TransAct POSjet 1500 Programmer's Manual page 231

Programmer' s Guide
Function Set Horizontal Tab Positions
ASCII [ESC] D <n
Hexadecimal
1BH 44H <n
Decimal
<27> <68> <n
Range 1 ≤ n ≤ 255
0 ≤ k ≤ 32
Description The [ESC] D <n
column number for setting a horizontal tab position. The command deletes any previously set,
horizontal tab positions. Up to 32 tab positions can be set. The default tab positions are at
intervals of eight characters for 7 x 9 font.
Note 1
In TM-U325D mode, the buffer must be set to 40 characters.
Function Set Left Margin
ASCII
GS L <n
Hexadecimal 1DH 4CH <n
Decimal <29> <76> <n
0 ≤ n ≤ 255
Range
l
0 ≤ n ≤ 255
h
Description The GS L <n
× 256) × horizontal motion unit)] from the beginning of the line. In standard mode, the
n
h
command is enabled only when input at the beginning of a line. In page mode, an internal flag is
activated, and the command is enabled when the printer returns to standard mode.
Function Set Printing Area Width
ASCII
GS W <n
Hexadecimal
1DH 57H <n
Decimal <29> <87> <n
0 ≤ n ≤ 255
Range
l
0 ≤ n ≤ 255
h
Description The printing area width is set to [(n
In standard mode, the command is enabled only when input at the beginning of a line. In page
mode, an internal flag is activated, and the command is enabled when the printer returns to
standard mode.
Function Turn ON/OFF Uni-Directional Printing Mode
ASCII
[ESC] U <n>
Hexadecimal 1BH 55H <n>
Decimal <27> <85> <n>
0 ≤ n ≤ 255
Range
Description The [ESC] U <n> command turns on/off unidirectional printing mode. When the least significant
bit (LSB) of <n> = 1, unidirectional printing is turned on. When LSB = 0, unidirectional printing
is turned off, and i-directional printing is turned on. Unidirectional printing can be turned on
when printing double-high characters to ensure that the top and bottom of the characters are
aligned. <n> = 0 is the default setting.
Function Set Left Margin
ASCII [ESC] l <n>
Hexadecimal 1DH 6CH <n>
Decimal <29> <108> <n>
0 ≤ n ≤ 255
Range
Description The [ESC] 1 <n> command sets the left margin using <n>. The left margin is set to <n>
characters from the beginning of the line.
Nov-07
POSjet
> ... <n > NUL
1 k
> ... <n > 00
1 k
> ... <n > <0>
1 k
> ... <n > NUL command sets the horizontal tab positions. <n> specifies the
1 k
> <n >
l h
> <n >
l h
> <n >
l h
> <n > command sets the left margin using n
l h
> <n >
l h
> <n >
l h
> <n >
l h
Rev M
®
1500
and n
l
× 256) × horizontal motion unit)] from the left margin.
+ n
l h
EPOS Control Codes
EPOS ONLY
. The left margin is set to [(n
h
EPOS ONLY
EPOS ONLY
Page 217
+
l