TransAct POSjet 1500 Programmer's Manual page 256

Data Processing and
Communications
Function Print Current Configuration and Totals
ASCII [ESC] y <9> or [ESC] ~ <9>
Hexadecimal
1BH 79H 09H
Decimal
<27> <121> <9>
Description
This command forces the printer to print the current configuration. To function correctly it must
be issued with the printer in the proper emulation mode. It is intended to be printed in the default
®
Ithaca configuration but will print in any configuration.
Note:
This command must be preceded with an ESC y <8>.
Function Print Current Totals
ASCII
[ESC] y <15>
Hexadecimal 1BH 79H 0FH
Decimal
<27> <121> <15>
Description
This command forces the printer to print the current totals log.
Note: This command must be preceded with an ESC y <8>.
Function Print Current Alignment Values
ASCII [ESC] y <20> or [ESC] ~ <20>
Hexadecimal
1BH 79H 14H
Decimal
<27> <121> <20>
Description
This command forces the printer to print the current alignment values.
Note:
This command must be preceded with an ESC y <8>.
Function Overlay the Small Draft font with Cartridge Test Characters
ASCII
[ESC] y <16>
Hexadecimal 1BH 79H 10H
Decimal <27> <121> <16>
Description This command forces the printer to replace characters 224 through 255 with test characters. Once
installed these characters can only be removed by reselecting the code page. Only the small draft
font is effected.
Function: Set Electronic Journal Print Configuration Control
ASCII: [ESC] ~ j <n>
Hex:
1BH 7EH 6AH
Decimal:
<27><126><105>
Description:
This command reconfigures the electronic journal print mode record separator and manual printing
modes
Where n =
76543210
------X0
------X1
------0X
------1X
Note:
Both parameters must be set at the same time by this command.
Note:
The Record separation configuration may be set in manual configuration mode. This command
will reset the configuration to the value specified here.
Note:
This command performs a configuration update, and should not be done on a regular basis.
Note:
This command must be preceded with an ESC y <8> to enable it.
Page 242
®
POSjet 1500
Bit values
Manual Electronic Journal Print mode is Enabled
Manual Electronic Journal Print mode is Disabled
A Record separation line is printed that may contain a record number.
No Record separation line is printed.
Rev M
Programmer' s Guide
Nov-07