Tm-U325D And Epos Command Descriptions; Print And Feed Commands - TransAct POSjet 1500 Programmer's Manual

Programmer' s Guide

TM-U325D and EPOS Command Descriptions

The TM-U325D and EPOS emulations are grouped together. The TM-U325D emulation is a subset of the EPOS
emulation. The EPOS only commands are noted.

Print and Feed Commands

Function Print and Line Feed
ASCII
[LF]
Hexadecimal 0AH
Decimal <10>
Description The [LF] command prints the data in the print buffer and feeds one line. The amount of paper fed
per line is based on the value set using the line spacing command. The default setting is 1/6 inch.
Function Print and Carriage Return
ASCII
[CR]
Hexadecimal
0DH
Decimal
<13>
Description
When auto line feed is enabled, [CR] functions in the same way as [LF]. When auto line feed is
disabled, [CR] prints the data in the print buffer and does not feed the paper.
Function Print and Feed <n> Lines
ASCII [ESC] d <n>
Hexadecimal
1BH 64H <n>
Decimal
<27> <100> <n>
0 ≤ n ≤ 255
Range
Description
The [ESC] d <n> command prints the data in the print buffer and feeds <n> lines. The amount of
paper fed per line is based on the value set using the line spacing command. The maximum paper
feed amount is 40 inches. The default setting of the paper feed amount is 1/6 inch.
Function Print and Reverse Feed<n> Lines
ASCII [ESC] e <n>
Hexadecimal 1BH 65H <n>
Decimal <27> <101> <n>
0 ≤ n ≤ 255
Range
Description The [ESC] e <n> command prints the data in the print buffer and feeds <n> lines in the reverse
direction. The amount of paper fed per line is based on the value set using the line spacing
command. The maximum reverse paper feed amount is 48/144 inch. The default setting of the
paper feed amount is 1/6 inch.
Function Print and Feed Paper
ASCII
[ESC] J <n>
Hexadecimal 1BH 4AH <n>
Decimal <27> <74> <n>
0 ≤ n ≤ 255
Range
Description The [ESC] J <n> command prints the data in the print buffer and feeds the paper [n x (1/144)]
inches, which means that the printer can feed the paper in half-dot units. The command is used to
temporarily feed a specific length without changing the line spacing set by other commands.
Nov-07
®
POSjet 1500
Rev M
EPOS Control Codes
Page 203