Programmer' s Guide
This allows the partition of the extended flash to
Electronic
be split between the electronic journal and the
Journal
user store. If the electronic journal is in use, this
feature can not be changed.
There is a manual means to print the electronic
EJ Print
journal. This feature may be disabled by this
Enable
option. If the print is disabled, the only way to
retrieve the EJ information is through the host.
By default the printer will print a record
EJ Print
separator between journal records. This may be
Separator
disabled by this option.
Options
Specifies that the cutter option is attached.
Cutter Option
Not present or disabled
Active
The printer can be configured to feed from 0 to
Knife Pre-Cut
26 mm of paper before the paper is cut.
Feed
If the auto cutter is not installed this value
or
becomes the tear point adjustment.
Tear Off
adjustment
Note: There may be additional options and/or features that appear in the configuration list. If you wish to alter any
of these undocumented features you should call Transact Technical support for assistance.
Nov-07
®
POSjet
1500
Table 16 Configurable Options
Rev M
Codes and Commands
64K to
The configuration depends on the
Electronic
amount of flash installed.
Journal
Enabled
Enabled
Off
May be from 0 to 22mm.
Page 57