TransAct POSjet 1500 Programmer's Manual page 66

Control Codes
Ink Low When Signal ink low when x% of the ink has been
At: used.
Ink Low is OFF (never signal ink low)
Ink Low when at 75%
Ink Low when at 80%
Ink Low when at 85%
Ink Low when at 90%
Ink Low when at 95%
Ink Low when at 100%
Print Zone Normal
Simulated 2.8"
Vertical Control
The line spacing can be defaulted to
Line Spacing
6 or 8 lines per inch (lpi).
6 lpi
8 lpi
An auto line feed feature can be set as a default
Auto
where all [CR]'s have a [LF] added. In
Line Feed/
addition, a CR is added to a LF, and the CR
Carriage
or LF can be configured to be ignored.
Return
Normal CR/LF actions. Both are processed.
Ignore all LF characters
Ignore all CR characters
Add a LF to all CR characters
Add a CR to all LF characters
Add a CR to all LF characters,
and add a LF to all CR characters
The default page length can be set to various
Page Length
lengths from 2 to 60 lines. Page length
configuration affects how the [FF] command
operates.
2 to 60 lines
Fonts
The default print mode can be set to 12 x 12
Font
draft, 12 x 14 large draft, or 24 x 32 NLQ
modes.
12 x 12 draft
12 x 14 large draft
24 x 32 NLQ
The default print pitch can be set to 8, 10, 12,
Pitch (CPI)
15, 17.1, 20, or 24 characters per inch.
8 cpi
10 cpi
12 cpi
15 cpi
17.1 cpi
20 cpi
24 cpi
Page 52
®
POSjet 1500
2.5"
Rev M
Programmer' s Guide
This sets the point when the
printer reports ink low. The
printer does not stop printing
at ink low
•
• This is accomplished by
shrinking the character
spacing.
This is not available in and
TM-U325 mode
This is the default for most
Epson printers
•
Setting Depends
on emulation.
Default for most Epson
printers.
•
Page length can be set in
PcOS, M50, And Microline
only.
40
This is not configurable in all
emulations.
•
PcOS Only
PcOS
Nov-07