Table of Contents
Advertisement
Control Codes
a form to be placed in the validation slot. If a form is already present in the printer, pressing the
move the form in a downward direction.
Open Cover Button
The
Button is used to access the rear paper roll compartment and is located on the top left side of the
printer's outer console.
Indicator Light Descriptions
POWER INDICATOR LIGHT
ERROR INDICATOR LIGHT
PAPER INDICATOR LIGHT
FORM INDICATOR LIGHT
LEFT CARTRIDGE INDICATOR LIGHT
RIGHT CARTRIDGE INDICATOR LIGHT
The descriptions below reflect the normal uses of the keypad indicator lights. These indicators are also used during
self-test and errors modes to convey additional information.
Power Indicator Light (LED)
The
Error Indicator Light (LED)
The
, along with the other indicators may be used to determine the cause of the problem.
Paper Indicator Light (LED)
The
supply has been exhausted, the printer will stop, and the
paper is reloaded, the indicator lights will be extinguished and the printer will resume operation. If the POSjet
is equipped with the optional paper low feature, the
decreases below a preset minimum. This indication is a warning only, the printer will continue to operate normally
until the paper supply is exhausted.
Form Indicator
The
the operator that the printer is waiting for a form to be inserted/removed in the printer. The
will change to a steady ON condition when a form is present in the printer.
Left and Right Cartridge Indicator Lights (LED)
The printer has two ink cartridge indicator lights that display the status of the ink cartridges. The indicator light will
blink slowly when the ink level in the respective cartridge falls below a preset, programmable level. It is a warning
only, the printer will continue to operate without intervention. When ink cartridge(s) are removed, or the ink
cartridge is defective, the corresponding light will blink at a faster rate. Printer operation is inhibited until the
cartridge is replaced.
Page 20
®
POSjet
Indicates printer activity and non-recoverable errors.
Indicates problems and probability of recovery.
Indicates paper status (paper low and paper out).
Indicates validation/inserted form status
Indicates ink levels of left cartridge.
Indicates ink levels of right ink cartridge.
becomes active when the printer is in the OPERATIONAL/ON mode.
becomes active when a problem is detected by the printer. The
is used to communicate the amount of paper remaining in the printer. When the paper
is used during form validation operations. The
Rev M
1500
and
will flash when the paper roll diameter
Programmer' s Guide
Button will
will illuminate. When
®
1500
blinks to alert
Nov-07
Advertisement
Table of Contents
Troubleshooting
