Table 52 Drawer Kick-Out Connector Status (<N> = 2, 50); Table 53 Values For The Status Function, <N; Table 54 Printer Status (<N> = 1) - TransAct POSjet 1500 Programmer's Manual

EPOS Control Codes
Bit Off/On
0 Off
On
1-3 -
4 Off
5,6 -
7 Off
Function Transmit Real-Time Status
ASCII
[DLE] [EOT] <n>
Hexadecimal
10H 04H <n>
Decimal <16> <4> <n>
1 ≤ n ≤ 4
Range
Description
The [DLE] EOT <n> command transmits the specified status in real time. The command is
executed if the printer is off line, the print buffer is full, or an error occurs. If the printer goes off
line due to a paper-end condition, bit 5 of the printer status (waiting for on-line recovery) is on
from the time the paper roll is inserted to the time the printer goes on-line. See the [GS] z 0
command for details of the on-line recovery wait time. The paper roll low sensor is an option. If
the printer does not have a paper low sensor, bits 2 and 3 of the paper roll sensor status will always
be "Paper adequate." Bit 3 of the second byte is always "No error occurred."
<n>
1
2
3
4
Bit Off/On
0 Off
1 On
2 Off
On
3 Off
On
4 On
5 Off
On
6 -
7 Off
21 ®
The POSjet 1500 does not require any operator intervention to recover from on-line recovery. The Insta-
®
Load feature will automatically restore the printer to the on line state. This bit is fixed to 0 in the TM U325D
mode. It is only active in the EPOS emulation.
Page 220
POSjet
Hex Decimal
00H <0>
01H <1>
- -
00H <0>
- -
00H <0>
Table 52 Drawer Kick-out Connector Status (<n> = 2, 50)
Transmit printer status
Transmit off line status
Transmit error status
Transmit paper roll sensor status
Table 53 Values for the Status Function, <n>
Hexl Decimal
00H <0>
02H <2>
00H <0>
04H <4>
00H <0>
08H <8>
10H <16>
00H <0>
20H <32>
- -
00H <0>
Table 54 Printer Status (<n> = 1)
Rev M
®
1500
Drawer kick-out connector pin 3 low
Drawer kick-out connector pin 3 high
Undefined
Not used; fixed to Off
Undefined
Not used; fixed to Off
Function
Not used; fixed to off
Not used; fixed to on
Drawer kick-out connector pin 3 low
Drawer kick out connector pin 3 high
On-line
Off line
Not used; fixed to on
Not waiting for on-line recovery
Waiting for on-line recovery
Undefined
Not used; fixed to off
Programmer' s Guide
Status
Status
21
Nov-07