Table of Contents
Advertisement
NE provisioning
Procedure 7-1: NE login via OSI
...................................................................................................................................................................................................................................
Overview
This section describes the login procedure to an NE using an OSI connection. It is
necessary that the WaveStar
"Connecting the WaveStar
NOTE: This is the only possible procedure for performing an NE login at this point in
the NE turn-up.
Required equipment
Prior to performing this task, the following equipment must be available:
1. WaveStar
2. CAT5 crossover LAN cable with RJ-45/RJ-45 connectors (see chapter 4,
4-48, "CIT connection (LAN crossed)" (p.
Prerequisites
Prior to performing this task, you must be logged in to WaveStar
(see chapter 5, section
(p.
5-18)) if WaveStar
installation.
Initial login procedure
Proceed as follows in order to log into the NE using an OSI connection:
...................................................................................................................................................................................................
In the WaveStar
1
enter the target identifier (TID) in the
of the NE) is: "UNITE-NE".
...................................................................................................................................................................................................................................
365-374-179R10.0
Issue 2, June 2009
®
CIT is already connected to the NE (see section
®
CIT to the NE" (p.
®
CIT PC
Procedure 5-4: "Starting the WaveStar
®
CIT User Login has been enabled during WaveStar
®
CIT
NE Management View
Alcatel-Lucent - Proprietary
See notice on first page
7-3)).
4-73))
(left window column; see figure below),
box. The default TID (= default name
NE Name
Figure
®
CIT as Super User
®
CIT application"
®
CIT
7-7
Advertisement
Chapters
Table of Contents
