Table 5-4 Creating A Community Entry - Cisco 15216 EDFA2 Operation Manual

Enabling SNMP Remote Management Community Strings
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
cerent15216EdfaCommName ""
cerent15216EdfaCommViewIndex 0
cerent15216EdfaCommPrivileges 35
cerent15216EdfaCommSrcIPAddr 0.0.0.0
cerent15216EdfaCommNetMask 0.0.0.0
cerent15216EdfaCommStatus 0
cerent15216EdfaCommStatus OBJECT-TYPE
Table 5-4
Table 5-4
Data Prompt
cerent15216EdfaCommIndex
cerent15216EdfaCommName
cerent15216EdfaCommViewIndex
cerent15216EdfaCommPrivileges
cerent15216EdfaCommSrcIPAddr
cerent15216EdfaCommNetMask
cerent15216EdfaCommStatus
Cisco ONS 15216 EDFA2 Operations Guide
5-8
SYNTAX INTEGER
{
active(1),
notInService(2),
notReady(3),
createAndGo(4),
createAndWait(5),
destroy(6)
}
MAX-ACCESS read-create
DESCRIPTION
::= { cerent15216EdfaCommunityEntry 7 }
displays the definitions for the community entry values.
Creating a Community Entry
Chapter 5
Description
Community Index: An index that uniquely identifies a
particular SNMP community. This community index is part of
the command. In Example 5-4 on page
Community Name: The community string.
View Index: The view index specifies which MIBs this
particular community string can access.
Privileges: A bitmap of access privileges that govern what
management operations a particular community can perform.
These privileges are expressed as a sum of values, where each
value represents a particular operation. Refer to
page 5-9 for the SNMP Operation Decimal Values.
Source IP Address: The IP address from which network
management traffic for this community originates.
NetMask: The subnet mask for the source IP address.
Status: The status of this conceptual row in the community
table.Use createAndGo to create a new row. Use active to
modify an existing row.
SNMP MIB Installation and Configuration
5-7, it is "3".
Table 5-5 on
78-16033-01