Set-Th-Dwdm; Table 9-51 Set-Attr-Secudflt Syntax Description; Table 9-52 Set-Th-Dwdm Syntax Description - Cisco 15216 EDFA2 Operation Manual

Chapter 9 TL1 Commands
Example 9-47 SET-ATTR-SECUDFLT Command
Amp01:ONS15216 EDFA2> SET-ATTR-SECUDFLT:Amp01::123::AL=RW,TMOUT=45;

Table 9-51 SET-ATTR-SECUDFLT Syntax Description

Parameter
al
timeout

9.7.45 SET-TH-DWDM

Command
SET-TH-DWDM
Sets optical threshold values for the ONS 15216 EDFA2.
Syntax
SET-TH-DWDM:[<tid>]:<aid>:<ctag>::<thresholdtype>,<thresholdvalue>[,,];
Example 9-48 SET-TH-DWDM Command
Amp01:ONS15216 EDFA2> SET-TH-DWDM:Amp01:ALL:123::LOSTH,-1500;

Table 9-52 SET-TH-DWDM Syntax Description

Parameter
aid
78-16033-01
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
Syntax
R
RW
RWA
0 - 99
Syntax
1
ALL
Description
Access level for which the timeout is being set. See
of Security Permissions for TL1 Commands" section on
page 9-6 for access level permissions.
Read only privileges.
Read and write privileges.
Read, write, and administrative privileges.
Value of the timeout in minutes for the corresponding access
level. Defaults are:
R = 60 min.
RW = 30 min.
RWA = 15 min.
0 means no timeout.
Description
1 and ALL have same input effect.
Directly affecting the optical signal.
Any or all of the preceding (command input only).
Cisco ONS 15216 EDFA2 Operations Guide
TL1 Commands and Autonomous Messages
"Summary
9-61